83GS550E eng case savers/guards square or round tube?

[GQROD]

Saw these on e-bay

I have seen square tube ones and these round tube ones, will the round tube ones fit a 1983 GS550E?, my frame is square tube but i like the round tube your help is greatly appreciated.

[Nessism]

What is your question? Seems to me either type will work. Take your pick.

[GQROD]

Excuse the confusion, my question was will the round tubes work?, i ask since my frame is square. I just wanted to make sure the round ones would fit. Thanks

[Big N daft]

Looking at that picture there is only one anchor point on each side and a section that links both parts. I'd say it should fit and if not could be made to fit but I'd rather get the square section ones which have more than one anchor point on the frame and are made for that frame.

[GQROD]

Looking at that picture there is only one anchor point on each side and a section that links both parts. I'd say it should fit and if not could be made to fit but I'd rather get the square section ones which have more than one anchor point on the frame and are made for that frame.

Thanks for your help, i think you are right. Although i can fabricate and weld i really just want a bolt on set, so it looks like square tube it is.