.png "Powered by vBulletin")
On my 79 GS1000 motor. There are 4 transmission bearings, they all take a half circular ring thats keeps them in place in the cases. 3 out of the 4 bearings use a tiny roll pin or dowel in them to keep them from spinning. I just so happen to be missing one of those small pins out of one of the smaller bearings. The other small bearing does not even have a slot for it. Do I really need this pin? Where can I get one. Its real tiny.
-
-
I did buy set of HD transmission bearings set from racing shop for GS1100.
I found they also without that small pins installed .
I just think do it really need that small pin.
someone told me place a drop of red-type screw glue will work fine.
I still haven't try. -
I think the pin is to keep the bearing from spinning in the case and causing case wear. I'd find one, auto shops should sell roll pins.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
-
well I work at a parts store. Ill see if I can find a tiny one.Comment
-
check mc mastercar, or just get some piano wire the same size as the hole and snip it to length78 GS1000 Yosh replica racer project
82 Kat 1000 Project
05 CRF450x
10 990 ADV-R The big dirt bike
P.S I don't check PM to often, email me if you need me.Comment
Comment