lookin for 1982gs1100L info

[coyotehunta]

hi there , i gotta 1982GS1100L and cant seem to find a place to buy or download a repair manual.....bike will run just not right on the inside cyl , seems they arent buring right theres a lil spark just guess not enuff. any body ran into this trouble before.....? if i can find a repair manual maybe thatd help, thank you.. email me if you know coyotehunta@yahoo.com thanks

[waterman]

Check out BassCliff's website:

http://members.dslextreme.com/users/bikecliff/

He has put everything together for us. Here you will find a manual.

[coyotehunta]

thank you much for the help...

thanks for the try i found his site its aweeesumm,bu my luck again stumped me i found everything but my model i think, sheshhh

[nathan12]

z1enterprizes.com

[coyotehunta]

thanks

thank ya much i;ll check that out..

[mriddle]

Most of the repair manuals that I have were found on ebay .. but you can buy them online new as mentioned above ..

[bubbabland]

same problem on kz1000p

recently had same problem on an 86 kz1000p retired police bike. thought it was a carb issue but went through em and no help. turns out the exhaust valves needed shimmed. running great now. I'd compression check each before going too far and see if everything balances out.

[82Shafty]

hi there , i gotta 1982GS1100L and cant seem to find a place to buy or download a repair manual.....bike will run just not right on the inside cyl , seems they arent buring right theres a lil spark just guess not enuff. any body ran into this trouble before.....? if i can find a repair manual maybe thatd help, thank you.. email me if you know coyotehunta@yahoo.com thanks

If the bike has high mileage, check compression first.

1) Check valve clearance---will need valve cover gasket
2) Pull all carbs apart, dip, replace o-rings,set float height etc. (o-ring kit and Berrymans carb dip)
3) Inspect intake boots and replace o-rings behind intake boots
4) If you have stock air filter make sure it is clean and air box is properly sealed
5) Ohm coils and replace spark plug resistor caps
6) Put it all back together and sync carbs

All of this stuff needs to be done to a 27 year old bike anyways, so you might as well start at square one, do it all right the first time, save yourself a bunch of wasted time chasing worn out compenents, and enjoy riding your bike the rest of the summer.

[coyotehunta]

lotsa thanks to EVERY1

Thanks a bunch every1,,, all great advice.

[focus frenzy]

1982 would make it a GS1100GL you need the shaft drive book from clymer.

clymer and factory manual available here:

http://www.repairmanual.com/motorcycles/1982/62/0/5619/228

[coyotehunta]

1982gs1100l

you maybe right,.maybe i got the year wrong.or the side covers wrong....it says 1100L, thanks for the site though, is there much diffrence you think......?it is shaft drive

[coyotehunta]

82gs1100l

still looking if any one cAN HELP, REPAIR MANUAL