.png "Powered by vBulletin")
Does anyone know what the specs. are for a 1980 550 L, or how to find them?
-
-
Did you check the factory service manual They list specific specifications for many of the bolts on the bike, and those without specific mention there is a table of general specifications based on the grade and diameter of the bolt. That said, exhaust bolts should not be very tight; they press the head pipe into the exhaust port which should have a fresh crush seal installed. A 1/4" ratchet handle and appropriate hand effort to tighten should be plenty. If you use a 3/8" ratchet handle, go easy - tighten with one hand and don't crank on it. Also, use some high temp anti-seize compound on the bolts.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection -
tscc models are 6.5 to 8.5 ft.-lb.
all other models are 6.5 to 10.0 ft.-lb. per the clymer manualI didnt do it I swear !!
--------------------------
http://i1210.photobucket.com/albums/...Picture003.jpg 1982 GS850G
http://i1210.photobucket.com/albums/...n1/Picture.jpg 1980 GS1100LComment
-
Thanks for the info. I do not have a manual yet but plan on getting one.Comment
Comment