GS425 carb question....

[Guest]

When I removed the carbs to rebuild them I failed to note which way this spacer ( btwn the cyl head and the carb flange) is orientated and I was hoping someone here knew. Is it A or B?

thanks
Zeebob


p.s. This is my 1st bike. I would have never considered an older motorcycle except when doing my research on GSs a co-worker offered to sell me I ran across this great site. It gave me the confidence to think I could actually get this beast running.
thanks again
Z

[Nessism]

I think that detail on the inside goes down. Check each one right and left and see if that makes sense.

[briyenkieth]

little humps go on the bottom.

[BassCliff]

Hi,

Aren't they labeled "R" and "L" on the intake boots themselves? I'll have to take a close look at mine.


Thank you for your indulgence,

BassCliff

[zeebob]

I looked everywhere..

but I found no marks on the spacers themselves. It was a while before I went to replace the carbs so all other "evidence" of parts mating, wear marks, etc had been disturbed.

thanks for the input
Zeebob