.png "Powered by vBulletin")
Hi Mr. zacheriaj,
I hope this will help answer some of your questions. Please click below for the PDF file.
Valve Adjustments (8 Valve)
As has been stated, do not confuse inch measurements with metric measurements.
In inches the spec range is .001" to .003", that's one to three thousandths of an inch.
In "metric" the spec range is .03mm to .08mm, that's three to eight hundredths of a millimeter.
If everything is too tight, you'll have to put a smaller shim in each bucket and take more measurements to see how close you are, then adjust accordingly. Please do not spin the motor without all shims in place. Keep us informed.
Thank you for your indulgence,
BassCliff
I hope this will help answer some of your questions. Please click below for the PDF file.
Valve Adjustments (8 Valve)
As has been stated, do not confuse inch measurements with metric measurements.
In inches the spec range is .001" to .003", that's one to three thousandths of an inch.
In "metric" the spec range is .03mm to .08mm, that's three to eight hundredths of a millimeter.
If everything is too tight, you'll have to put a smaller shim in each bucket and take more measurements to see how close you are, then adjust accordingly. Please do not spin the motor without all shims in place. Keep us informed.
Thank you for your indulgence,
BassCliff
Comment