Wiring on GS550

[old_chopper]

I completed my "abbreviated" wiring harness for my '80 GS550L, runs good and is charging. There are two wires I do not have connected yet and need some help. These are the third phase as discussed in the stator papers.
They are:
From R/R - White with Red stripe
From Stator - White with Green stripe
These used to run through the ignition switch and the headlight selector. How should I hook these up since I will not have a headlight on/off switch?

[Redman]

The red/wht wire, is it from the R/R, or is it from the wireharness (handlebar controls)?

The grn/wht wire, is it from the R/R or it it from the wireharness (handlebar controls)?

If they are the wires from the wireharness from the handlebar controls, well, those are the ones you dont need anymore that used to go to the headlight switch. Dont need to be connected to anything. THe connector up in the headlight shell has those two jumpered toghether rather than go to headlight switch.

If those two wires are from the R/R and from the stator, then those two can be connected directly together (rather than going up to the nonexistant headlight switch and back thru the wiring harness and 4 other connections).

You have a schematic?
I have some for 850 & 1100s, But I think this part about the stator leg that goes to the nonexitant headlight switch is the same on many models.
.

[old_chopper]

They are from the R/R and Stator. There is no harness anymore. To make certain you said to hook these two together. Correct? I do have the schematic from BC's website. Thanks!

[Redman]

Yep.
That way the three legs of the stator are connected to the 3 inputs to the R/R.

.