.png "Powered by vBulletin")
I just got done cleaning out my carbs and am wondering what I should set my air/fuel screws at...Its a 1982 Gs650G all stock, except for a kerker 4 into 1 exhaust. I thought I remember reading it was either 1.5 or 2.0 turns out, not sure though...
-
-
Before bothering with the mixture screws, how did you clean the carbs?
Have you changed the main jets?
Did you shim the needles?
Get those taken care of, then you can set the mixture screws between 2 and 3 turns out, then fine-tune from there.
.sigpic
mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
#1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
#2 son: 1980 GS1000G
Family Portrait
Siblings and Spouses
Mom's first ride
Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
(Click on my username in the upper-left corner for e-mail info.) -
Everything is set, I am just wondering where I should start, I guess 2 turns out is as good as any then.Comment
-
2-2.5 turns is your starting point........Comment
Comment