Announcement
Collapse
No announcement yet.
valve in prime position, but no fuel draining
Collapse
X
-
joviyach
valve in prime position, but no fuel draining
Hi all, I finally got around to getting my gas tank off today en route to getting the carbs off, but funny thing is that though I have a nearly full fuel tank (of 2+ year old gas) nothing came out. Is this an indicator that the valve may be bad? BTW... I found the vacuum leak. There was a hose coming from under the gas tank that was not attached to anything. I am guessing that it is suppose to go to a connection in between the two carbs on the right that had no hose connected to it.Tags: None
-
BassCliff
Hi Mr. joviyach,
See the following for pictures and comments:
Where Do These Hoses Go?
On the bottom side of the tank, inside where it fits around the frame, there is a long hose that comes from the fuel gauge send unit and drains down behind the engine, past the battery box, to the ground in front of the rear wheel.
Yes, if your petcock does not drain anything when set to "PRIME" then I would get a new one. Have you looked at the filter screen on top of the petcock? Is the tank full of grunge and rust? I suppose the petcock could be clogged.
Thank you for your indulgence,
BassCliff
-
Forum LongTimerGSResource Superstar
Past Site Supporter
Super Site Supporter- Mar 2006
- 35622
- Torrance, CA
One exception to the above comments is the 1980 petcock without a slot which requires a quick vacuum pulse to open the prime (or so I've been told).Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection
Comment
-
He's right, with the "80" model petcocks, when on "PRI" you will need vacuum on the petcock to get the fuel flow started, after it starts it will keep flowing. Not just my opinion, I've been there.1983 GS1100E, 1983 CB1100F, 1991 GSX1100G, 1996 Kaw. ZL600 Eliminator, 1999 Bandit 1200S, 2005 Bandit 1200S, 2000 Kaw. ZRX 1100
Comment
-
joviyach
That explains it, but
unfortunately makes the leak...still a mystery. It would have been easier if those hose were actually supposed to be connected to something on both ends, now I am thinking the culprit must be the boots after all, which is what I originally assumed. I will probably just replace the petcock.
Comment
Comment