.png "Powered by vBulletin")
How much finesse does it require to get the cover off the air screw port? I have a replacement in the rebuild kits, but should I just drill it out (carefully)?
Oh, BS32SS Mikuni carbs here.
Oh, BS32SS Mikuni carbs here.
-
Last edited by Guest; 08-19-2009, 09:10 PM. -
The archives has tons of info on how to take out the cap. The search function is a wonderful thing!
Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection -
Tried search function, but coudn't find this exact issue...must have gone to the wrong place...I'll try again.Comment
-
Try the Advanced Search and limit the search to "titles only". You will find it!Originally posted by hakuin View Post
HINT - search for "cap".
Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
-
Got it, thanks!
"Drill a hole in the cap and pull it out with a screw. Back the drill out as soon as you penetrate to not damage the screw head."Comment
-
Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
-
It's really easy too. Just remember that you aren't drilling through steel so don't push too hard. If you drill it out with a small bit first, then the screw doesn't remove it, don't worry. Use progressively larger bits and you will eventually take it out so that you either have it stuck to your drill bit or it has one complete side removed and it can just be pulled out.Comment
-
1st carb rebuilt, 3 to go!! Thanks again.
Comment
Comment