Announcement

Collapse
No announcement yet.

Removing push-pull throttle cable

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Removing push-pull throttle cable

    Doh!

    OK, here is another dumb question:

    How do I remove this push-pull cable so I can remove my carbs? It's a little hard to work on the carbs with them still attached to the bike!




    Many thanks (again)
    Last edited by Guest; 09-30-2009, 11:51 AM. Reason: typo

    #2
    crack off the bottom nuts and unscrew fully. then lift the cables out and unhook the cable nipples
    1978 GS1085.

    Just remember, an opinion without 3.14 is just an onion!

    Comment


      #3
      Do the front one first as he says. Loosen the nuts on the second cable. Then open the throttle with the twistgrip, block the throttle mechanism open between the carbs with one hand or perhaps a block of wood and release the grip. You can get the second cable adjuster out of it's slot, and then the end of the cable out of the little throttle wheel easily now.

      Also you may find it easier to remove the cables when the carb rack is already partway off the engine, off to the side where you can reach the cable ends better.
      http://img.photobucket.com/albums/v5...tatesMap-1.jpg

      Life is too short to ride an L.

      Comment


        #4
        Originally posted by tkent02 View Post
        Do the front one first as he says. Loosen the nuts on the second cable. Then open the throttle with the twistgrip, block the throttle mechanism open between the carbs with one hand or perhaps a block of wood and release the grip. You can get the second cable adjuster out of it's slot, and then the end of the cable out of the little throttle wheel easily now.

        Also you may find it easier to remove the cables when the carb rack is already partway off the engine, off to the side where you can reach the cable ends better.
        Hi, which one is the "front"? Is in the cable on the left in my photo?

        Thanks,
        -Bob

        Comment


          #5
          Originally posted by littleroot View Post
          Hi, which one is the "front"? Is in the cable on the left in my photo?

          Thanks,
          -Bob
          I said it wrong, do the rear one first. Do the one that pulls the throttle open last.
          http://img.photobucket.com/albums/v5...tatesMap-1.jpg

          Life is too short to ride an L.

          Comment


            #6
            Originally posted by tkent02 View Post
            I said it wrong, do the rear one first. Do the one that pulls the throttle open last.
            If i remember right the one of the left opens the throttle (pulls?) and the other one closes it (pushes). Sorry to be so clueless but which should I remove first?

            Comment


              #7
              Originally posted by littleroot View Post
              If i remember right the one of the left opens the throttle (pulls?) and the other one closes it (pushes). Sorry to be so clueless but which should I remove first?
              The easiest one.
              http://img.photobucket.com/albums/v5...tatesMap-1.jpg

              Life is too short to ride an L.

              Comment

              Working...
              X