Wheel stand supports

[Guest]

I need to drill and tap some 3/8in holes for wheel stand supports.

The pic shows two potential locations on the swingarm.

Does anyone see any concerns for structural integrity afterwards.

[kinnet]

Is an adjustable swingarm stand that doesn't use spools not an option for you?

I got one for TCK just recently and we like it a lot.

[Agemax]

structuraly, no probs. problem is if you use position A you may compromise wheel nut removal.

[posplayr]

I need to drill and tap some 3/8in holes for wheel stand supports.

The pic shows two potential locations on the swingarm.

Does anyone see any concerns for structural integrity afterwards.

Assuming A and B are both into solid aluminum then B is much stronger. I would be concerned about A breaking out the bottom of the fork.

[Mysuzyq]

There are stands available that use small adapters, to lift the bike by the bottom of the swing arm itself. I'll be looking for one of these myself, in a few weeks, rather than drill/tap the arm. I'll post the info if I find it, though you may as well proceed if you've already bought a spool-specific stand.

Tony.