"SIGNAL" fuse constantly blowing

[harasyn92]

I do believe this problem started after I took my gas tank off, but i could be mistaking. Anyway every time i replace my "signal" fuse, it just blows. I am using the correct fuses. What could the problem be?? My bike model is an 86 GS550ESG.

[Steve]

Well, the first thing to do is to grab a wiring diagram and start following it.

In a nutshell, that fuse supplies power to the turn signals, horn(s) and brake lights.

Look for pinched wires, especially at the front of the tank.

.

[almarconi]

You probably pinched a wire.

[BassCliff]

Hi,

Yes, take your tank off again (and the seat and side covers while you're at it). Look for wire with damaged insulation. Check/clean/repair connectors as necessary. Check my website for electrical system tips. Here's a little welcome message for you....

Here is your very own magical, mystical, mythical, mind-expanding "mega-welcome". Please take notice of the "Top 10 Common Issues", the Carb Rebuild Series, and the Stator Papers. Now let me roll out the welcome mat for you...

Please click here for your mega-welcome, chock full of tips, suggestions, links to vendors, and other information. Then feel free to visit my little BikeCliff website where I've been collecting the wisdom of this generous community. Don't forget, we like pictures! Not you, your bike!

Thanks for joining us. Keep us informed.

Thank you for your indulgence,

BassCliff

[coolksprt]

It's all about the grounds. I had corrosion in one of my sockets and the circuit wasn't being finished because of the rust was preventing the ground. After getting a wire brush in there and making my own ground with some copper wire, all the blinkers worked fine and I didn't worry about the fuse.

Kev

[harasyn92]

hey thanks alot for the advice guys! I have a Haynes manual and will follow the wiring diagram today. Also, this fuse also powers my display board. So i currently have to tach, tach light or any other lights such a neutral or gear position lights. Wish me well