.png "Powered by vBulletin")
I'm pulling apart the carbs on my 1980 GS850 for the first time. I've been using the GSresources guide on carbs. Well, I got to the air screw and it is different than th photos. No slot for a screw driver--just a pinhole. Any ideas on how to remove the air screw? I'm at a loss...I suppose I can just clean the carbs without removing the air screw???
-
-
That's an aluminum cap over the screw. Take a sheet metal screw and screw it into the cap and then lever the cap out, some people drill the cap first. Be careful to not go too deep though the cap if you drill.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection -
1983 GS 1100E w/ 1230 kit, .340 lift Web Cams, Ape heavy duty valve springs, 83 1100 head with 1.5mm oversized SS intake valves, 1150 crank, Vance and Hines 1150 SuperHub, Star Racing high volume oil pump gears, 36mm carebs Dynojet stage 3 jet kit, Posplayr's SSPB, Progressive rear shocks and fork springs, Dyna 2000, Dynatek green coils and Vance & Hines 4-1 exhaust.
1985 GS1150ES stock with 85 Red E bodywork.
Comment
-
-
how deep does the cap go? I've strated a screw and the cap isn't coming out. So i've drilled a bit, but don't know how deep I need/can go?Comment
-
It's about 2mm thick, there is a small space (2 - 3mm) before the screw itself. I like to twist the drill in by hand to avoid going too deep.Comment
.png)
Comment