Fuel Tanks Connections

[indyjoel]

Hi all

I am trying to put the gas tanks back on the gs650 shaft drive 1983 model

I thought I had an understanding of the connectors.

On the AUS model there is the petcock and then the other side has the fuel send module (I think)

I think the connections are as follows:

1. petcock (big hose from carb, and small hose from carb)
2. Fuel sender module (two electrical connectors)
3. Fuel send pipe (I am not sure where this goes)

When I put fuel in and turned it to reserve the fuel was coming out from a small pipe that I am not sure about (any ideas)

Joe

[indyjoel]

Further Update to my stupidty

1. petcock
big hose from carb that goes to a connection on the back end of the carb
small hose from carb front of the carb

2. Fuel sender module (two electrical connectors)

3. Fuel send pipe (I am not sure where this goes)

Another pipe from the carb front I think that I am not sure where this goes onto the tank

When I put fuel in and turned it to reserve the fuel was coming out from this small pipe that I am not sure about (any ideas)

[almarconi]

Your carbs should have 4 hoses
1. large hose to petcock(fuel hose)
2. small hose from #2 carb to petcock (vacuum hose)
3&4. Vent hoses that hooked to T between carbs that are draped over air box

Your tank has
1. Petcock with 2 nipples, 1 large to carb for fuel, 1 small to vaccuum port on #2
2. electrical connector for fuel sender/gauge if your bike has one
3. over flow tube - long tube that you route away from carb area, usually exits near swing arm in front of the tire.

[BassCliff]

Hi,

See if this information helps...

Where Do These Hoses Go?

I found it on some guy's website.


Thank you for your indulgence,

BassCliff