Announcement

Collapse
No announcement yet.

Eliminate battery monitor

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #16
    Is that a curious HMMMMMMMMMMM? If i simply turn the key to "on" the battery light,along with the other warning lights stays on until the bike fires up . Actually the bike had not been started since I took posession until the carbs were cleaned and re-installed yeaterday. Runs great, rides nice but rear suspension is too soft even on the highest settings on pre-load and re-bound. Hope original mono-shock is not shot.

    Comment


      #17
      i haven't owned an 1150 for several years so i really forget.
      i remembered the bat light not being on at all after it was hot wired to 12 volts.
      like i said,
      its been several years so i could be mistaken.

      Comment


        #18
        My batt wire is connected directly to the batt. +, on my "83" GS 1100. Yesterday, I went to crank it up, for the 1st time since December & found the batt. completely dead. I had installed a new Interstate AGM, last summer, so am thinking the batt indicator probably does draw current all the time, if not connected to a switched source. Just my opinion!!!
        1983 GS1100E, 1983 CB1100F, 1991 GSX1100G, 1996 Kaw. ZL600 Eliminator, 1999 Bandit 1200S, 2005 Bandit 1200S, 2000 Kaw. ZRX 1100

        Comment

        Working...
        X