Announcement

Collapse
No announcement yet.

anyone know Martek?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    anyone know Martek?

    Does anyone know how to setup a Martek 400S ignition? I have a 78 750 and I just redid all gaskets, and I goofed up the martek 400s ignition in the process.

    #2
    Can't help with the Martek, but I would like to know where you found gaskets. I have a '77 750 and can't find gaskets anywhere on the net.

    Thanks,

    Terry

    Comment


      #3
      Dennis Kirk has a full set of the gaskets for 88.95. Great deal if you ask me. I had to order rings separately for 130 dollars, and the little rubber end capsdon't come with it, but it's got base, head, valve cover, exhaust valve stems, o-rings, clutch cover, starter/stator cover, points cover and oil pan gaskets... there's more little onces too I think Dennis Kirk has an online catalog, if they don't list it, they have catalogs that the send for free I believe

      Comment


        #4
        Thanks! I checked them out and will purchase a set when I get back from vacation. Wish I could help with your problem.

        Terry

        Comment


          #5
          Anyone know Martek?

          Place Alignment pin on crank at top position.Place complete
          assembly back into place with T.F. 1.4 at top,Turn rotor and
          advance mechanism until alignment pin on shaft engages slot
          on advance mechanism hub.

          When doing this make sure hole in rotor rim is to the left and
          T.F. 1.4 is to the top.

          Align timing pointer to timing plate.Tighten screws.No advance
          or retard needed.

          Hope this helps.

          Martin

          Comment

          Working...
          X