Announcement

Collapse
No announcement yet.

think i screwed up

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    think i screwed up

    i bid on an 97 GSXR stock carbs 38 mm downdraft with EFI, is their ANY chance this will fit on a 82 GS11E

    #2
    Re: think i screwed up

    Originally posted by bostrom155
    i bid on an 97 GSXR stock carbs 38 mm downdraft with EFI, is their ANY chance this will fit on a 82 GS11E
    I've never heard of carbs with EFI...you have either carbs or you have EFI. If they are carbs, they may fit with some alternations to the intake manifolds. You would need pod filters of course. If it is EFI, it would be next to impossible to make work.

    Hap

    Comment


      #3
      Can you post the E-Bay link to these carbs. Maybe will tell you what they are.
      1166cc 1/8 ET 6.09@111.88
      1166cc on NOS, 1/8 ET 5.70@122.85
      1395cc 1/8 ET 6.0051@114.39
      1395cc on NOS, 1/8 ET 5.71@113.98 "With a broken wrist pin too"
      01 Sporty 1/8 ET 7.70@92.28, 1/4 ET 12.03@111.82

      Comment


        #4
        this is the site for the carbs


        Comment


          #5
          I bought a set of GSXR 750 38mm carbs last week from StripBike.com for my GS1100e. They look alittle different at the bowls than those you are biding on and my throttle cable hooks up between the two middle carbs compare to yours which hooks up at the side of one carb. It's hard to tell but those carbs may have accerator pumps with all those lines at the base of the carbs??. I don't know what year mine are but I think they are older than the ones you are biding on. Mine even fitted on the OEM boots with alittle force and have 135 main jets which may be stock.

          But from that picture yours may be 36mm or 38mm carbs and should work ok, you may have to angle or tilt the top of the carbs toward the engine to get the fuel bowls level. I used a coat hanger around the frame down towards the carbs to tilt mine.

          Just wait until the last minute and watch that bid go out of sight. I had two bids that I thought I won but did'nt.

          Good Luck
          Jake
          1166cc 1/8 ET 6.09@111.88
          1166cc on NOS, 1/8 ET 5.70@122.85
          1395cc 1/8 ET 6.0051@114.39
          1395cc on NOS, 1/8 ET 5.71@113.98 "With a broken wrist pin too"
          01 Sporty 1/8 ET 7.70@92.28, 1/4 ET 12.03@111.82

          Comment


            #6
            Yeah, if you bid too early people will raise it one dollar at a time just to see what your max bid is. They probably won't take it from you if you've bid enough but it could cost you 20 bucks or more as each person comes and goes. I won a water purifier today with 8 seconds to spare which is pretty good for a slow connection. I had to wait that long because there was somebody bidding 2$ at a time every few minutes trying to get it.

            Cheers, Steve

            Comment

            Working...
            X