Removing Front Sprocket - PLZ HELP!

[Anonymous]

Hey guys, Im replacing my 14T font sprocket with a 15T. I have the cover off and I am ready to take the sprocket off. What are the steps I need to take to do this correctly?

Thanks

[Hoomgar]

Put the bike in gear and have a friend hold the rear brake on.
Then you can break the nut loose easily. That's the worst of it.

The rest is gravy. Just put the new one on the same as the old one
as far as any washers and whatnot unless it is not the same width?

Not sure if they make then standard width or not.

[Anonymous]

Ok thanks very mich, but what about adjusting the chain? Is that necessary? Will it change the free play at all?

[Anonymous]

Might have to loosen the chain a little. The 15t should have a larger circumference.

[Hoomgar]

What he said

You will have enough room to just come front a hair with your rear wheel.
I am doing the same exact thing.

[Anonymous]

Ok. Do I just release the rear wheel spindle nut and slide it on the swingarm?

[Anonymous]

Disregard that last post, I got it on ok. Lost a little bit of acceleration, but I had tons to start with. All went fairly well. Thanks again for the help!

-Matt