.png "Powered by vBulletin")
my rpms are sticking and i'm pretty sure the cause is that the sildes arent sliding like they should and in order to get new diaphragms the place i get my parts can only get them with a slide attached. so it would come out to $180 which is waayy more than i want to pay, so does anyone know where i can get just the new diaphragms?
-
-
Have you tried a little wd40 or the like on the slides...Push em up and down be hand? Feel that gentle suction...whish...Check there first...Operate the throttle while looking into the carbs and see if any are hanging...may be mechanical outside the carbs...Only take a few minutes and its free..EULC ON -
yeah, i did lube those suckers up with wd-40 a couple of times, but i havent looked in there to see if they were hanging. any other ideas?Comment
-
A good cleaning should do the trick, Or clean/polish the slides very gently with a 2K grit wet dry paper.
The diaphrams can be repaired Check with
Comment
Comment