Announcement

Collapse
No announcement yet.

oil level lens replacement GS850G

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    oil level lens replacement GS850G

    Hi
    Does the oil level lens plug go in on the back side of the cover or front side?
    Been looking on the web to find out for sure .. but couldn't find anything.
    Thanks
    GDtractor

    #2
    Backside. You have to remove the clutch cover to replace it.

    Hap

    Comment


      #3
      got the cover off ... and got the sight glass-- (?)

      Hi Hap ..
      Thanks much .. got the cover off ... and got the sight glass ...

      Does the sight glass just set in there or do you push in and "snug" it even with the cover or what?

      I know I should have a book ...

      Thanks
      GD

      Comment


        #4
        Anything the clymers can tell you, you can figure out yourself.
        It's just that useless.
        So don't feel too bad.


        Dm of mD

        Comment


          #5
          When I replaced mine I just put a thin film of black RTV on it and pushed it into place.

          Comment


            #6
            Did it .. swanny ..

            Swanny .. I just put a film of rubber cement that I have used for fixing flat tires and pressed it in .. it is snug and in good ...

            Put it back together .. and put new oil in and started it up ...

            (the clutch seems more loose than it was but I didn't try to put it in gear(

            It runs good now ... and starts good .. AS LONG AS I have the choke ON ALL the time ... I think the carbs need cleaning bad !!
            again thanks ...
            gd

            Comment

            Working...
            X