Approx cost for big bore kit?

[jkevbriggs1]

Can anyone tell me what it cost for a big bore kit and machining the cylinders?

[runewolf]

It depends on the bike and the company you have do it.

http://www.wiseco.com/ has one to take my 750 to 844cc for $541

[brveagle]

when i bored out my cylinders, it was $60 a cylinder. This was this winter

[lecroy]

I assume when you say "big block" your talking a solid block.

Depends what your wanting. I think I paid around $1400 or so for the last setup. Pistons were right out of the box (no gas porting, etc). Block, sleeves, buttons and pistons came from MTC. Rings are standard. APE made me some very nice wrist pins for it. Then the machining, setup, head gasket and base shims.

[Big Jay]

Can anyone tell me what it cost for a big bore kit and machining the cylinders?

You will find that info here;

http://gszone.biz/pistons.html

For a bore in kit without resleeving, it is $95.00 all four holes.

Jay

[lecroy]

Looks like your competative with MTC's prices.

[madjack57754]

For $60 a hole, I'd start looking for a boring bar

[jkevbriggs1]

You will find that info here;

http://gszone.biz/pistons.html

For a bore in kit without resleeving, it is $95.00 all four holes.

Jay

Oh man, that web site is like a candy store for GS kids. Thanks.

[Big Jay]

Oh man, that web site is like a candy store for GS kids. Thanks.

Thanks. I am sure there is no other GS site on the web like ours.

Jay

[80gs1100]

I had a block bored and cleaned for $100.00 at a place called united speedworld in tampa...very professional guys in there, I think they do a lot of dragracing stuff. Meawhile the mc shop down the street wanted 200.00, and a suzuki dealer wanted 350.00

[humblepie]

Did they make ever a big bore kit for the Gs550's?

[brveagle]

Did they make ever a big bore kit for the Gs550's?

No, but with some work you can get the 650 top end to fit

[RacingJake]

I had a block bored and cleaned for $100.00 at a place called united speedworld in tampa...very professional guys in there, I think they do a lot of dragracing stuff. Meawhile the mc shop down the street wanted 200.00, and a suzuki dealer wanted 350.00

I bet they would out source it to the same place you went too and they still make $100-$250 profit without doing a thing. Getting around the middle man can save a few bucks.

[Suzukfan78]

Hp?

Is 100 Hp/75 ftlbs realistic if I bump my 8 valve GS1000 motor to 1100, 10.1 compression, K&N filters, quality pipe, dyna coils and ignition, new set of cams, and larger carbs?

[Suzukfan78]

Im talking at the rear wheel of course...