.png "Powered by vBulletin")
I have decided to put a really strong and tight 1150E motor in my project bike (titled "down to the frame"). I was wondering if my adjustable aftermarket higher lift cams would drop in? (don't need tach gear)
-
-
Yeap 1100 and 1150 cams can be swapped with no problems.1166cc 1/8 ET 6.09@111.88
1166cc on NOS, 1/8 ET 5.70@122.85
1395cc 1/8 ET 6.0051@114.39
1395cc on NOS, 1/8 ET 5.71@113.98 "With a broken wrist pin too"
01 Sporty 1/8 ET 7.70@92.28, 1/4 ET 12.03@111.82 -
Thanks RacingJake I'm even happier about the 1150 motor now! I'm going to stick my RS 38s on there as well.Comment
-
It should run really good with those carbs, what size cams are you going to use??1166cc 1/8 ET 6.09@111.88
1166cc on NOS, 1/8 ET 5.70@122.85
1395cc 1/8 ET 6.0051@114.39
1395cc on NOS, 1/8 ET 5.71@113.98 "With a broken wrist pin too"
01 Sporty 1/8 ET 7.70@92.28, 1/4 ET 12.03@111.82Comment
-
The cams measure 20 thou more than stock for lift with the same base circle as stock.Comment
-
I've ran G4's about .355 lift in a 1100 and 1150 head and they work really good too.
Good luck, and don't forget to double check the timing and valve clearance.1166cc 1/8 ET 6.09@111.88
1166cc on NOS, 1/8 ET 5.70@122.85
1395cc 1/8 ET 6.0051@114.39
1395cc on NOS, 1/8 ET 5.71@113.98 "With a broken wrist pin too"
01 Sporty 1/8 ET 7.70@92.28, 1/4 ET 12.03@111.82Comment
Comment