1100 to 1150 swingarm!

[rjloope]

Could someone send pictures of there conversion form dual shock to mono shock?? i think its pretty simple just dont know where to weld the brackets!! thanks

[Big_T_111]

Swingarm

I have used an 1150 arm before but on this project I used a Katana 750 arm because it was made out of steel and I could weld and cut it easy. I extended it 7" inches then made mounts for a 1996 Kaw ZX11 shock. The stock 5.5 GSXR wheel will fit right in these swingarms. I did all the work myself with some simple tools and a wire welder. Hope this helps.

[rjloope]

ya that helps thanks!! was it hard to figure out were the you have to weld the the bar fro the top shock mount and what about the bones??

[rjloope]

I have a 5.5 whell also did you have to use a offset sproket in the front???

[Big_T_111]

Swingarm

Since this bike was for the track it only uses the shock. I welded a mount and brace right behind the gas tank mount. I spaced the shock back a bit to allow for the swingarm length. It really works well. I did have to space the 530 front sprocket out some.

[rjloope]

thanks You wouldnt have a close up pictures would you??

[saffa]

man thats one bad ass mofo of a bike you got there .busy doing one myself . kicking myself now for sticking with the twin shock set up .