.png "Powered by vBulletin")
^have to add to the above...you also lose your steering stops.
Mounted up...
Took a bit of effort to get her there but worked out ok in the end...I wish I didn't have four other people's bikes in my garage so I could have had some room but oh well...
Had to cut an 8mm spacer to stack the lower bearing on. 5mm would have been fine, keep that in mind...it was hard to measure, though, so I went overboard to make sure. I'll be cutting a proper grease-bucket style insert to stack the bearing on later. My current stock was a little lacking for the project.
Oooooooo nice clip-ons too...
Mounted up...
Took a bit of effort to get her there but worked out ok in the end...I wish I didn't have four other people's bikes in my garage so I could have had some room but oh well...
Had to cut an 8mm spacer to stack the lower bearing on. 5mm would have been fine, keep that in mind...it was hard to measure, though, so I went overboard to make sure. I'll be cutting a proper grease-bucket style insert to stack the bearing on later. My current stock was a little lacking for the project.
Oooooooo nice clip-ons too...
Comment