.png "Powered by vBulletin")
so i see now how i have to make the mount to get it to work and i also had to file down some of the flange that goes into the head on the left 2 cyl. as your looking at it from the front. its still a tight fit as i dont own a dremel (note to self invest in one) so it was a long task. now if my exhaust gaskets will get here soon i will be able to mount it up and fine tune the muffler placement so it doesnt contact the rear foot pegs and make a god awful noise when riding or getting on it hard.
now i was thinking could i add some HD rubber of some sort to the old mount so if it does hit it wont vibrate or rattle really bad? like some tar paper or something better? up for suggestions.
and i only have 1 more carb to dissassemble and dip while im waiting for my orings and gaskets. so i should be good to go by the end of the weekend.
now i was thinking could i add some HD rubber of some sort to the old mount so if it does hit it wont vibrate or rattle really bad? like some tar paper or something better? up for suggestions.
and i only have 1 more carb to dissassemble and dip while im waiting for my orings and gaskets. so i should be good to go by the end of the weekend.
Comment