Announcement
Collapse
No announcement yet.
Slow to return to idle after dynojet and carb rebuild
Collapse
X
-
24flinchin
Slow to return to idle after dynojet and carb rebuild
83 650g I just rebuilt the carbs ( dipped and all new o-rings) and installed the dynojet stage 3 kit. It starts and idles good but when I snap the throttle and release, it sounds fine going up in RPMs but slow to return to idle. Any suggestions? Thanks in advanceTags: None
-
rosco15
-
twiggy2cents
-
Bribird
check and make sure your throttle cable is not tweaked a bit at where it attaches to the bracket on the carbs. Did you remember to put the air corectors in and drill the slides?
Did you go with the 160 or 155 jets? What exhaust are you running? pod filters?
Comment
-
24flinchin
thanks for the responses. I went with the 160s and i did drill the slides. Some cheap pod filters, emgos i think... Ill check the linkage
Comment
-
Billy Ricks
These jet kits are really running some rich mains these days. My DJ kit from years ago came with something like 119 mains for a GS700. They must be using some fat needles now.
Comment
Comment