Slow to return to idle after dynojet and carb rebuild

[24flinchin]

83 650g I just rebuilt the carbs ( dipped and all new o-rings) and installed the dynojet stage 3 kit. It starts and idles good but when I snap the throttle and release, it sounds fine going up in RPMs but slow to return to idle. Any suggestions? Thanks in advance

[rosco15]

Sounds too rich on the pilot.

[twiggy2cents]

lean makes the rpms hang

rich makes it drop under the idle speed

[Bribird]

check and make sure your throttle cable is not tweaked a bit at where it attaches to the bracket on the carbs. Did you remember to put the air corectors in and drill the slides?

Did you go with the 160 or 155 jets? What exhaust are you running? pod filters?

[24flinchin]

thanks for the responses. I went with the 160s and i did drill the slides. Some cheap pod filters, emgos i think... Ill check the linkage

[Billy Ricks]

These jet kits are really running some rich mains these days. My DJ kit from years ago came with something like 119 mains for a GS700. They must be using some fat needles now.