.png "Powered by vBulletin")
Does anyone know who might still make offset counter shaft support systems? Kosman has stopped making them for the 1150.
-
-
see my reply in tech section.... -
Hi again Rob,
If you have no luck finding one I can have one made up for you same as mine (see major 1100 kat rebuild).
it's about 65.00 usd. for a 3/8 offset.Comment
-
-
If you find a company that sells them post it....Because I searched everyone and couldn't find anyone who makes them anymore for our bikes.
katmanComment
-
Sprockets
www.pmfronline.com has the offset sprocket with the support plate assy for the 1150. It goes for 400.oo usd.Comment
-
right.
I wasn't looking for the support unit, just the sprocket and they only have the sprog with the nose.
pretty priceeeeeee.....Comment
-
call them to confirm....
I called a few places that had them listed on line but no longer carry them.
good luckComment
-
MRE has the offset without the nose....ask for Jay.Comment
-
starracing.com has them 5/8 15t for 530 chain for around 60.00
DaveComment
-
630 front sprocket for the Kawa GPZ750 '83-'85 has 6mm offset.. 15 tooth, the same spline sizes as GSX1100.
Source: www.katanaclub.nlComment
-
offset counter shaft supports
Robert......
Try MRE (Murdoch Racing Enterprises)in Florida. I think they handle D&G products. Their phone is 1-800-237-RACE. Or, e-mail at MRERACE@aol.com.
Kevin RogersComment
-
Wasnt it the 750 turbo that had the 630 drive chain? The years of manufacturer certainly seem to tie up with that idea, and I know my gpz turbo runs a 630..Originally posted by robinjoComment
-
The ordinary GPz750 A1---
Had 630 sprocket I used to have one..
Did you know that the turbo version have a race mode??
I think it was 135 HP
GS1000GLxComment
-
get a 530, it will clear the frame a lot better
PMFRComment
Comment