.png "Powered by vBulletin")
I have a GS11 ET which is going thru' its first change (handling).
The next two changes depend on money and time so after the current
work is done it's going back on the road YAAAAAAAY.
Anyway, my problem is this I have fitted a complete front end from a GSXR1100 WP, bolted straight on like a dream.
The back end is a little bit trickier I have the 5.5 rear wheel of the aforementioned Gixer with the armless caliper hanger,
I read through a lot of the posts here and found Katmans schematic of the bushings required http://groups.msn.com/GS1100KATANA/1...oto&PhotoID=23
can anyone give any advice on this, my main question is about the spacer on the LHS next to the sprocket. The drawing shows 12.5mm is this the spacer overall length or from the face of the bearing seal.
Apologies for length and thanks in advance for your help.
Les
The next two changes depend on money and time so after the current
work is done it's going back on the road YAAAAAAAY.
Anyway, my problem is this I have fitted a complete front end from a GSXR1100 WP, bolted straight on like a dream.
The back end is a little bit trickier I have the 5.5 rear wheel of the aforementioned Gixer with the armless caliper hanger,
I read through a lot of the posts here and found Katmans schematic of the bushings required http://groups.msn.com/GS1100KATANA/1...oto&PhotoID=23
can anyone give any advice on this, my main question is about the spacer on the LHS next to the sprocket. The drawing shows 12.5mm is this the spacer overall length or from the face of the bearing seal.
Apologies for length and thanks in advance for your help.
Les