Project 1100 Bandit/Gsxr conv

[jwhelan65]

RAG check completed...

[jwhelan65]

Got em out, it looks like they are the culprit, kind of blurry but you can see the oil stains down the bolt housing. The O-rings looked ok at first glance, but after a closer look they were scarred to the inside. Cleaned up the tensioner also.

[jwhelan65]

Ok, shop is set up so back on the 1100 project. Waiting on the valve job so begining to line up the rear sets...

[jwhelan65]

The new shop is starting to take shape.

[jwhelan65]

An 82 1100E reduced to a cabinet and a few shelves..

[jwhelan65]

But not for long.

[rapidray]

I'm starting to HATE you Joe!!! Ray.

[russr33]

Joe have you already moved?

[jwhelan65]

Had the covers done by GS Ace...thanks Frank!

[Cassius086]

Looking good, Joe! Are the side covers polished and clear coated, or just polished?

[jwhelan65]

Looking good, Joe! Are the side covers polished and clear coated, or just polished?

Just polished for now...

[jwhelan65]

Made a little guard for my oli cooler..

[midnightcafe]

Made a little guard for my oli cooler..

That looks like light fixture mesh, I have some myself from work. Just wondering, where can you buy the stuff??

[jwhelan65]

That looks like light fixture mesh, I have some myself from work. Just wondering, where can you buy the stuff??

It's actually perforated metal I buy it in bulk, I make these over on the FZ1 board for radiators..

[Candyman]

Looks beautiful.