.png "Powered by vBulletin")
the new to me carb showed up 
now i can finally finish these things and move on to the next project
now i can finally finish these things and move on to the next project
-
-
Done
actually not really. just waiting on the new pilot jet plugs to show up then itll be 100% doneComment
-
Secondary gear oil changed out and rotted rusty mufflers gone!
Comment
-
Careful now, next thing you know this will be down to a bare frame and a pile o parts, then powdercoat, polishing, and painting. Before you know it you'll have a new bike!Comment
-
I dont think I want to do that much work on this thing haha.Originally posted by Smokinapankake View Post
from here its gonna get fork seals, brake flush, most likely new rotors, and go through the electrical system and strip out all the crap I dont want and then tidy it up. Essentially its gonna have the turn signals removed completely and the brake light moved. Find a speedometer, cut an inch of foam out of the seat (ive got short legs
) pull the pet cock apart and make sure things there are good, wrap the exhaust, finish the exhaust out to the back of the bike. . . . this list is depressing 
Comment
-
Never make a list.....
Comment
-
Have a look at Gatekeepers project. It started out as an oil change, I think....Comment
-
im just dying to start this thing up haha. Hopefully tuesday next week Ill be able to. Ill have the new plugs in the carbs then ill be able to slap them on. although I think I have to replace on of the hoses that I pulled off. It was quite brittle and cracked. Dont remember which one thoughComment
-
pulled the front forks off for new seals
my make shift work area haha
Carbs back on the bike
Comment
-
Got my new pilot jet plugs today and they went it perfectly! now just waiting to hear about the o-rings for the needle seat to come in.
on a side note, found out my jeep needs new hubs up front, found the tie rod ends are shot and that I may have a bent axle shaft. sad day
Edit: cant figure out how to imbed the video but its of the jeep if anyone cares
Comment
-
She LIVES!!!!!!!!!
I got the battery charged, oil changed, made sure there were no gas leaks just have to adjust the idle back down and get the front forks back on.
ill see if i can get a video tomorrow of her running.
also got a new helmet
Comment
-
started her up again today and there was no hesitation or anything however even after adjusting the idle on saturday shes back to idling high. ~2300 RPM high
tomorrow I should have my forks back
Comment
-
got the front forks back finally and put on and also bled the brakes and cleaned out the throttle cable so it snaps back like it should. Didnt have time to test for a leak and mess with the carbs though.
the front sits an inch lower now too
Comment
-
chillin with the other bikes
Comment
Comment