Announcement
Collapse
No announcement yet.
Wheelie bars installed. No traction
Collapse
X
-
Went to the track on Thursday... Ran 10.39 at 128. It sure is fun with the wheelie bars. I am getting used to the amount of thrust with the slick. After the evening was over, I realized that I was spinning in second due to too much air pressure. Next time I will adjust after the tire gets warm. I think I felt the clutch slip a little in 3rd... watching for a lock up spacer as the next purchase...sigpic'85 GS1150 1428 14-1 200+hp Hang On
Comment
-
chandler
congrats isnt it cool to just let it eat right from the get go. the best way now is just watch your 60 fts you will notice once you get it close little adjustments can make big results. another trick with the tire pressure i use nitrogen in my rear slick pressures dont fluctuate with the heat .
congrats on the quick times
steve
Comment
-
forget nitrogen it is a waste of money unless you have a sponsor buying it for you.
CO2 or just air is almost free and predictable- bixler is P.A.D.I. cert and he uses scuba tanks in the shifter and tyres. I use good 'ol CO2
I would suggest getting a higher quality low pressure gauge
9psi is not always 9 psi from gauge to gauge and if you have a off gauge you might just have 11 psi in there.
if you have a pyrometer check the middle and sides adjust until to get them all the same temp. and check your specific gauge and note it in your log book
low pressure the sides are hotter
high pressure the middle is hotter
better check it is not clutch slip bacause that little slick stays planted unless you have incredible H.P.
c ya tonightSUZUKI , There is no substitute
Comment
Comment