Announcement
Collapse
No announcement yet.
One of my Clutch Adjustment cover bolt heads broke off
Collapse
X
-
One of my Clutch Adjustment cover bolt heads broke off
I just noticed it the other day and i really wanted to get in there to adjust my clutch but one of the heads was broken off clean! now to give you a mental picture its the clutch adjustment cover that comes off of the sprocket cover... these were all allen heads and i think i tightened one of the heads too much and now theres just no more head there.. easy out? last time i tried an easy out the bolt was to hard and all the easy out did was make a little groove and couldn't cut through... should i just take the thing to a shop and have them take it out? thanks for reading guys ANY ideas would be great except for welding because i might as well just take it toa shop..Last edited by GabrielGoes; 09-30-2010, 10:40 PM.John 3:16Tags: None
-
JEEPRUSTY
Originally posted by GabrielGoes View PostI just noticed it the other day and i really wanted to get in there to adjust my clutch but one of the heads was broken off clean! now to give you a mental picture its the clutch adjustment cover that comes off of the sprocket cover... these were all allen heads and i think i tightened one of the heads too much and now theres just no more head there.. easy out? last time i tried an easy out the bolt was to hard and all the easy out did was make a little groove and couldn't cut through... should i just take the thing to a shop and have them take it out? thanks for reading guys ANY ideas would be great except for welding because i might as well just take it toa shop..
sheared off where it enters the case or juts the head broken off?
-
TheCafeKid
Bah... do you NEEED it? prolly not. If you want to get it out, a left handed drill bit would be keen. Or, start small, work your way up with bits, and bobs your uncle. A drill press would be mighty handy...
Comment
-
Originally posted by TheCafeKid View PostBah... do you NEEED it? prolly not. If you want to get it out, a left handed drill bit would be keen. Or, start small, work your way up with bits, and bobs your uncle. A drill press would be mighty handy...John 3:16
Comment
-
TheCafeKid
Originally posted by GabrielGoes View Posthmm very true, so your saying just drill the crap out of it untill the whole thing is just a big hole? sounds good to me!
Comment
-
cyclefvr2
kinda sounds like its broke off at the outer case?, then take all the other ones out, take the cover off and remove the broken (stud like )part thats left with vice grips
Comment
-
bobthebiker88
before attempting o remove the bolt, I would advise gently tapping the end a little with a hammer and punch. I've had bolts where doing this breaks the corrosion bond between the two metals and lets the bolt unscrew a little easier. try it.
Comment
Comment