Announcement

Collapse
No announcement yet.

GS1000 cylinder block removal - i:e barrels

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    GS1000 cylinder block removal - i:e barrels

    I'm having problems removing the barrels from the crankcase.Has anyone got any ideas on how to go about this - without damaging them.
    Many thanks Martin

    #2
    You'll probably get more answers if you post in the Tech section.

    Just a thought.

    Satch

    ps. I don't have any suggestions I'm a mechanical neophyte.

    Comment


      #3
      Stuck bits

      Ther are 2 steel dowels at the bottom of the barrels were your problem lies as well as the gasket. Place a block of wood on the side of the barrels and GENTLY tap the wood going fron side to side. The dowels are around the front outside studs so a little spray of WD40 would not go astray there. All that salt on the roads must be good hey!

      Comment

      Working...
      X