Late model 6'' rear wheel conversion

[Guest]

I'm running a McIntosh swing arm with a 6 inch Hayabusa rear wheel. I have a 5/8 offset 530 front sprocket. My issue now is the chain is hitting the the inside of the peg, where the 2 bolts hold it on to the rearset. What is the best solution to fix this? It seems if I grind the bolts, there won't be anything left to secure the peg. Any suggestions would be great. Thanks

[posplayr]

Extend the peg mounts out so you have more meat for the threads outboard of the tire.

[salty_monk]

If it's very minimal then use a thinner chain... There is a competition grade O ring 520 chain that is strong but thin. I remember a guy who Monoshocked a GS1000 on here using it. (PJ)

[bobgroger]

If it's very minimal then use a thinner chain... There is a competition grade O ring 520 chain that is strong but thin. I remember a guy who Monoshocked a GS1000 on here using it. (PJ)

I think finding a 5/8 offset GS spline 520 sprocket might be tough...

[salty_monk]

The whole build thread is on here... he had a source for those too!

[GregT]

520 chain - plus convert the bolts it's hitting to countersunk heads....

[Fjbj40]

I think finding a 5/8 offset GS spline 520 sprocket might be tough...

You can machine a 530 down to a 520 width as they are the same pitch.

[unfocused]

https://shop.pbisprockets.com/main.sc;jsessionid=4EF2DB7C63B68D0492FE6695B83AAB64.p3plqscsfapp006