vtr 1000f front end swap

[wheels]

Good point, I will measure the train tonight . appreciate the input did realize but yes the forks are close . I will find the lenght on stock offset axle forks also .

[wheels]

Also have an 1978 gs 1000 standard frame and they look exactly the same. I could not find any difference. Again, thank you.

[wheels]

Okay i believe i need help in the rake trail area and how to figure out the degree between offset and rake the trail turned out to be 60mm the rake is 314mm. used a carpenter angle gauge it's about 77degrees or 121/2 inches from center line of axle to center of upper triple? Does this make sense to you? thank you for your help

[wheels]

The bandit rear swing arm bolted right on after drilling out swing arm mounts to accept larger bandit swing arm bolt.