.png "Powered by vBulletin")
Hi all,
Purchased some koni cb750 shocks for my GS1000 (gs1100 swingarm). Most specs are pretty close, shocks are 13.35" long vs 12.80", travel is comparable. Bushings are pretty easy to swap. Spring rate is identical.
The problem is the clevis is approx 3mm too narrow(cb clevis is ~19.5mm GS clevis was measuring about 22.5mm). There is plenty of meat on the koni clevis for grinding but I figured I should ask for thoughts, advice, etc before I pull the dremel out and start grinding.
Anyone got any tips on grinding or on ensuring proper fitment? Any words of wisdom that will help avoid another mistake?
Purchased some koni cb750 shocks for my GS1000 (gs1100 swingarm). Most specs are pretty close, shocks are 13.35" long vs 12.80", travel is comparable. Bushings are pretty easy to swap. Spring rate is identical.
The problem is the clevis is approx 3mm too narrow(cb clevis is ~19.5mm GS clevis was measuring about 22.5mm). There is plenty of meat on the koni clevis for grinding but I figured I should ask for thoughts, advice, etc before I pull the dremel out and start grinding.
Anyone got any tips on grinding or on ensuring proper fitment? Any words of wisdom that will help avoid another mistake?