I installed a swingarm bearing facing backwards...will something terrible happen?

[Guest]

i installed new swingarm bearings, then i noticed that one of them is "reversed" the side with text is facing inside.
i'll hate to ruin this fairly expensive bearing (almost 20$ a pop) trying to extract it.
would it be terrible if i leave it like this?
also, should it go all the way in up against the little shoulder? i used an allthread and 2 large disks to insert it and the i used the old bearing with a plastic mallet but i couldn't get them more the about 1-2 mm in beyond the edge
eran

[Agemax]

it will work fine the direction you have it, although it should be tapped in home against the shoulder. try a socket to tap it in if you can find the right size that will tap the bearing in without getting jammed in the swingarm