86 gs550 fork cap

[Guest]

All i wanted to do was repaint my handle bar parts so i un screwed the end cap on the fork tube on one side,bad decision i didn't realizehow much pressure was in the tube, anyway the the cap flew off and now resides somewhere in my garage where i havent a clue .Does anyone know where i can get,buy or trade for another(these are the one with air shocks)or can i use one from another model suzuki? they seem to be discontinued
PleaseHELPme thanks

[Agemax]

try looking a bit harder, it has to be there somewhere. saves the hassle and money to buy another one!

[Thumper88]

Similar problem when I was rebuilding my GS450 forks...
Was assembling them with new progressive springs....damn thing slipped out of place in my shop press (using as a third hand) and cap/clip/spacer went flying in different directions.

Eventually I found everything....look harder. Found my cap on the highest shelf in my garage.

[Seaking]

Did you look up, like stuck into the ceiling? I haven't taken mine apart yet but can just imagine what THAT's going to be like since the 83 GS650G top of the fork setup is different than most..

[JEEPRUSTY]

nice part bouncy and rolly. Good luck on the search it probably time to sweep up the garage anyway.

[derwood]

pop the other one off, it should go to the same place.

[Thumper88]

pop the other one off, it should go to the same place.

lol....not likely