Progressive Suspension: 11-1110 Fork Spring kit

[MK3Brent]

So I was thinking... Since I have the fork shown above with the secondary pre-load spring, and it happens to be slightly longer than the required lowering. I'm debating using it as my lower spacer, vs. the PVC pipe I have.

With the spring, I would have better fluid flow past the holes in the damper and might work better.

What do you think about that?

I currently have the lower forks curing with primer, so I have time before going back and putting it all together.

Just an update: /\
This doesn't work.. lol, the spring ID is too small.

I'm trying to seat the guide bushing into the lower fork tube.
I measured the height of the bushing, and the seat.. and I think I need to go back to the store to get a piece of pvc pipe to get more force around it.







That edge of the bushing should be flat with the fork seal seat.
I could also put it in the freezer for an hour or so, and I bet it would pop in.