Rear caliper sticks after new SS lines and rebuilding MC and caliper.

[GateKeeper]

you have a wire brush ?, snip off a wire from it, use needle nose pliers to hold it and poke away, and or push it into a wooden match, and then use that to poke at the hole to clean it up

I would not use anything that could enlarge the hole, I would be afraid of making it too big.....

.

[Strobot]

That was the problem. I could not see there was a second hole in the cylinder. It was definitely clogged. I used a pick from a set I picked up at auto zone to break through the crud. When I got through, I was able to push a 1/16" drill bit through by hand and work the crud out. I'm going to ride tomorrow morning and see how it goes. Thanks again for all of the support.

the pic shows the crud once I was able to push through.