Announcement

Collapse
No announcement yet.

First flat tire experience.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    First flat tire experience.

    Yes, it was bound to happen, I’m sure it’s happened to most of you. First motorcycle flat. I’d been out riding the dirt/packed gravel forest roads for a couple of hours. Picked up what must be a very pointy stone. When I pulled out from the dirt road left turn onto the paved road, the rear end went all squirrelly, no grip. I saved it but knew something was wrong. Bike didn’t want to ride in a straight line and the rear end just felt loose. I was only about 1/4 mile from Halfway Dam at RB Winter State Park. A popular spot to camp and swim in Central PA.




    If you’re going to break down this seems like the ideal spot. A wide parking area and plenty of people around. Except, there is absolutely no cell service. A very nice old couple offered to give me a ride to the ranger station to find a phone. They did, and I did, to call AAA and then my wife to let her know what’s going on/ where I was. AAA Operator told me my membership didn’t cover motorcycle hauling (I need to look into that), so I’d have to pay the flat bed driver whatever they charge, but they should be at my location within the hour. I figure I have no choice so I thanked the young lady ranger manning the station for the use of the phone and walk back to my bike and I wait.

    The old couple waited with me for about the first half hour, but figured I was OK and left. 1 hour, 2 hours, 3 hours. By this time it’s dark and all the swimmers and fishermen have left. The only thing around are a campground on the far side of the lake, and the ranger station. The young lady ranger comes and goes a few times and checks on me. She let me know that if I needed to, I could sleep in the vestibule of the station. At least I’d be warm and dry. Really hoping it wouldn’t come to that.

    4 hours, my wife finally comes along to see if there’s anything she can do. I had her go find cell service and call AAA to find out WTF. It was well over another hour until she got back to me, Til she got gas and some food/water for me and about a half hour getting someone at AAA on the phone. Said they tried to text me but I had no service. Apparently the would not be able to send someone to me with the required equipment until 9am.

    Well, there was no way I was leaving the bike. So I told her to just follow me with her 4-ways on. We’d take it slow. It’s after 11pm and this road in dark and lonely. I figured if the tire wasn’t toast already, it would be by the time I got it home/if I got it home. I’d need a new tire but save the towing/flatbed fee, whatever that was going to be.

    What surprised me a bit, was that after It got dark and I was the only vehicle there in the Dam parking lot, clearly a broken down motorcyclist, not one of the 2 dozen or so cars even slowed down to check if I was OK.

    So, I rode the the bike on a flat rear tire at around 15mph, for the 15 miles back home. That hour has my arms feeling like rubber this morning. I don’t want to ever risk doing that again. I was woefully underprepared for a flat.

    When I feel like getting up and around I’ll clean up the rear tire and see if I think it can be plugged. But I probably trashed the tire riding on it.

    I have some ideas for some things I’d like to get to keep in my bike pack for puncture flats in the tubeless rear.
    This plug kit
    This small compressor

    For the front, which has a tube, I suppose I’d need tire irons and a tube patch kit or spare tube.

    I’d love to read about the gear any of you carry to address flats on your bikes.
    Rich
    1982 GS 750TZ
    2015 Triumph Tiger 1200

    BikeCliff's / Charging System Sorted / Posting Pics
    Destroy-Rebuild 750T/ Destroy-Rebuild part deux

    #2
    A plug kit, and small compressor. That's it.

    Haven't had to use it yet, but I've plugged enough car tires to know how.

    As for the front, ditch the tube next time you replace the tire.

    Oh....And very glad you made it home OK.
    Bob T. ~~ Play the GSR weekly photo game: Pic of Week Game
    '83 GS1100E ~ '24 Triumph Speed 400 ~ '01 TRIUMPH TT600 ~ '67 HONDA CUB

    Comment


      #3
      A couple of cans of foamy repair aerosols, which have worked well on previous occasions.
      Come to think of it, it's been years since an on-road puncture and the cans I carry are getting old enough to worry about them working at all.
      Must replace them asap.
      I've also been looking at the plugging kits and small compressors as an alternative.
      ---- Dave

      Only a dog knows why a motorcyclist sticks his head out of a car window

      Comment


        #4
        my beemer came with a patch kit w/3 of those little CO2 bottles and an adapter to inflate a tire. i have a tool kit in my old gs1000g that has an electric pump and small tire irons. i guess for them to really be useful i'd need to find a new tire but every little bit helps.

        i tried the foamy tire repair stuff once on a tubed tire. it didn't work.

        not surprised about aaa not helping. that whole deal always seemed shady to me.
        2002 bmw r1150gs 1978 gs1000E skunk les pew 1979 gs1000L dragbike
        82 gs1100L probably the next project
        1980 gs1000G the ugly 1978 gs750E need any parts?
        https://m.youtube.com/watch?v=m_m2oYJkx1A
        1978 gs1000E skunk #2 RLAP
        https://live.staticflickr.com/65535/...2f1debec_t.jpg

        Comment


          #5
          I’ve had to use AAA enough with cars that’s it’s seemed worth it. Never a Break-even, but usually good service and that little bit of extra insurance has helped in some pretty tough situations where it would have been really expensive otherwise. I really do have to look into adding motorcycle to my membership but it wouldn’t have helped last night.
          Rich
          1982 GS 750TZ
          2015 Triumph Tiger 1200

          BikeCliff's / Charging System Sorted / Posting Pics
          Destroy-Rebuild 750T/ Destroy-Rebuild part deux

          Comment


            #6
            Glad you got it sorted. Relying on other people (like AAA) sucks. Best to be self sufficient if possible.

            I've got this kit and it works great. Used it just the other day to fix a screw hole through my daily driver car's tire.
            Buy Stop & Go 1000 22 Piece Tubeless Tire Pocket Plugger Repair Kit for Punctures and Flats on Car, Motorcycle, ATV, Jeep, Truck, & Tractor (15 Mushroom Plugs): Tire Repair Tools - Amazon.com ✓ FREE DELIVERY possible on eligible purchases


            They also sell a version with CO2 inflators so consider that version instead if you don't carry a pump.
            Ed

            To measure is to know.

            Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182

            Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846

            Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf

            KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection

            Comment


              #7
              BTDT ! That thing with AAA made me much more angry than what you seemed to be. The tow was 12 miles @ $12 a mile. GRRRrrrrr!!!! I did try FAF (fixaflat) but all that did was cause the tire to spin on the rim as I tried to drive up the tow truck ramp. I have a truck but no ramps or trailer. Next time .....(depends on the situation) Ill just source out a rental trailer.

              and looking at that pic Id say you needed a new tire anyway........
              82 1100 EZ (red)

              "You co-opting words of KV only thickens the scent of your BS. A thief and a putter-on of airs most foul. " JEEPRUSTY

              Comment


                #8
                I have used many rope/plug systems over the years. All of them required cement/glue to insert and seal the plugs. The only failure I had with them was the one time I used a very minimal amount of glue, in the hope that it would set quicker and I could get back on the road quicker. It was VERY hard to insert the plug, so in desparation, I used a lot more glue. The plug went in easily and seemed to set quickly enough to ride after grabbing a burger. The other difficulty of using them is when the tube of cement/glue dries up and renders the kit useless.

                I had seen Brian (bwringer) post something about the kit that he carries, so I contacted him. On his recomendation, I now carry a kit from the Nealey Company that does not require any glue at all. I have had occasion to use it twice now, it works perfectly. Also have a small compressor (might be from Harbor Freight) to handle inflattion duties. One word of advice if you carry a compressor: make sure you have a way to power it, then test it every couple of months to make sure it still works.

                .
                sigpic
                mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
                hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
                #1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
                #2 son: 1980 GS1000G
                Family Portrait
                Siblings and Spouses
                Mom's first ride
                Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
                (Click on my username in the upper-left corner for e-mail info.)

                Comment


                  #9
                  I have a sticky rope plug kit which has served well over the years. Only ever had one on the bike and I spotted that screw at home. Lost less then ten psi in the repair and a footpump was enough.
                  They are such a rare event and almost always late in tyre life. Our daily car has no spare just one of those bottles of evil gloup and a ciggy lighter compressor.
                  I laid them on the drive to examine them and the dog cocked his leg on the lot. That about sums up that idea
                  Last edited by Brendan W; 08-16-2020, 01:25 PM.
                  97 R1100R
                  Previous
                  80 GS850G, 79 Z400B, 85 R100RT, 80 Z650D, 76 CB200

                  Comment


                    #10
                    Why do I have The Duct Tapes running through my head when reading this thread? The only time I ever had a flat away from home, I was in Ft. Wayne IN in the evening when I ran over a nail or something and was stuck for the night. Everything was closed. Ran the '82 1100E to a service station and tried to get a little sleep until they opened in the morning. They said they were busy and handed me a couple of tire irons and a patch kit. So I took the wheel off, patched the tire, and got the (bleep) home. Ive always hated using tire irons and patch kits, but at least I knew how.
                    Expecting the Spanish Inquisition
                    1981 GS850G: the Ratzuki
                    1981 GS1100E

                    Comment


                      #11
                      Originally posted by zuluwiz View Post
                      Why do I have The Duct Tapes running through my head when reading this thread?
                      You can't get there from here...
                      Ed

                      To measure is to know.

                      Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182

                      Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846

                      Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf

                      KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection

                      Comment


                        #12
                        I had to go from AAA to AAAPlus to get motorcycle towing. goes to 100 miles radius from home
                        1978 GS 1000 (since new)
                        1979 GS 1000 (The Fridge, superbike replica project)
                        1978 GS 1000 (parts)
                        1981 GS 850 (anyone want a project?)
                        1981 GPZ 550 (backroad screamer)
                        1970 450 Mk IIID (THUMP!)
                        2007 DRz 400S
                        1999 ATK 490ES
                        1994 DR 350SES

                        Comment


                          #13
                          Originally posted by Baatfam View Post
                          A plug kit, and small compressor. That's it.

                          Haven't had to use it yet, but I've plugged enough car tires to know how.

                          As for the front, ditch the tube next time you replace the tire.

                          Oh....And very glad you made it home OK.
                          This, x 100.
                          "Thought he, it is a wicked world in all meridians; I'll die a pagan."
                          ~Herman Melville

                          2016 1200 Superlow
                          1982 CB900f

                          Comment


                            #14
                            Originally posted by Big T View Post
                            I had to go from AAA to AAAPlus to get motorcycle towing. goes to 100 miles radius from home
                            State Farm covers mine for towing.
                            "Thought he, it is a wicked world in all meridians; I'll die a pagan."
                            ~Herman Melville

                            2016 1200 Superlow
                            1982 CB900f

                            Comment


                              #15
                              When my stator cooked far from home a guy in our group had AAA with RV coverage. It covered a bike tow.

                              I picked up a drywall screw in my back tire years ago in Maryland. The tire was leaking minimally. I bought a rubber mushroom plug kit with the CO2 cartridges. I plugged it a gas station with an airpump and saved the CO2. The plug held up until I had to replace the tire a year or 2 later.

                              No idea on if the CO2 is a good option.
                              sigpic
                              When consulting the magic 8 ball for advice, one must first ask it "will your answers be accurate?"

                              Glen
                              -85 1150 es - Plus size supermodel.
                              -Rusty old scooter.
                              Other things I like to photograph.....instagram.com/gs_junkie
                              https://www.instagram.com/glen_brenner/
                              https://www.flickr.com/photos/152267...7713345317771/

                              Comment

                              Working...
                              X