Hose help.

[Cipher]

5 months and I've yet to replace my GS brake hose. Oh well....
Most vendor sites are crappy but https://ca.helperformance.com/custom-brake-hose
Is nice. I did a lookup for fitment on alpha sports using the seal and union bolt specs as a guide to give me this:

LENGTH - 100cm

SPECIFICATIONS

• COLOURBLACK

• FITTING ONEBANJO - M10 / 3/8"
• FITTING ONE ANGLE20°
• FITTING TWOFIXED MALE - M10 X 1.00
• FITTING TWO ANGLE
• SUPPORT ONERUBBER GROMMET
• SUPPORT TWO
• HEATSHRINKYES
• LENGTH100cm

Can anyone help confirm? 83 gs 550
I was pretty shocked by the 7ish cm the old hose stretched whilst I attempted to straighten it. to measure length.
its far more shocking than the perception of firmness when gripping it and applying pressure
Isn't that 7%?

[Nessism]

That looks like a bill of materials for making brake lines. Very little can be learned from it.

[Cipher]

Its a list made from entering the presumed fittings and measured length with a few variables such as colour and heat shrink tubing.

Some of the items are not applicable so no description shows up.

Basically I have measured the old assembly at 100 cms.
The union bolt ( Banjo bolt ) is 10x1.00x24 as per the parts fiche number so the corresponding banjo fitting must be 10mm and its certainly at 20 degrees.
The caliper has this bit attached. the bottom hose end has a straight fitting so I checked the size by threading in the union bolt so the treads match and are m10x1.00.

I am confused by the m10 3/8 spec on the aftermarket website not sure if that's a fit.

[salty_monk]

Aren't you near Apex? Lots of people seem happy with his work and he has most of the GS stuff in his database....