1150 Starter Clutch Question

[King Speed]

This bike is making me work for it. I completed the charging system upgrade, works great. Rebuilt and re-jetted the carbs, runs great. Put the bike back together and went to fire it up one last time to verify that the final assembly was good and "whing-a-ding-ding-ding" the starter clutch is no longer attached to the rotor.
What is the optimum route to rebuilding/replacing/modifying the starter clutch? I have read through the various threads, and am uncertain whether the bolts rattled loose, sheared off or what happened...but I will be disassembling the rotor/starter clutch and looking for the proper parts to make it right...the starter clutch casing is no good anymore from initial look inside stator cover.

 

[tom203]

I'm not fully awake yet, but I seem to remember someone talking about a delay before ignition fires plugs, so less chance of kickback as starter clutch engages.

 

[King Speed]

Did not Kick Back

Did not Kick Back

I think it is a good idea to set up the delay for starting the bike, or timing retard... but this did not happen because of it kicking back, most likely from (previous) wear on the clutch internals. With the engine running at a low idle, the clutch would rattle bad. It may be that it has been kicked in the teeth before, as I have only had this bike for a short time. I will be looking for a Rotor Removal Tool, and tearing it apart for a proper look at what happened.

 

[tom203]

Yes. a hard starting (i.e. poorly maintained ) bike is likely tough on the starter clutch .