• Required reading for all forum users!!!

    Welcome!
    Register to access the full functionality of the GSResources forum. Until you register and activate your account you will not have full forum access, nor will you be able to post or reply to messages.

    A note to new registrants...
    All new forum registrations must be activated via email before you have full access to the forum.

    A Special Note about Email accounts!
    DO NOT SIGN UP USING hotmail, outlook, gmx, sbcglobal, att, bellsouth or email.com. They delete our forum signup emails.

    A note to old forum members...
    I receive numerous requests from people who can no longer log in because their accounts were deleted. As mentioned in the forum FAQ, user accounts are deleted if you haven't logged in for the past 6 months. If you can't log in, then create a new forum account. If you don't get an error message, then check your email account for an activation message. If you get a message stating that the email address is already in use, then your account still exists so follow the instructions in the forum FAQ for resetting your password.

    Have you forgotten your password or have a new email address? Then read the forum FAQ for details on how to reset it.

    Any email requests for "can't log in anymore" problems or "lost my password" problems will be deleted. Read the forum FAQ and follow the instructions there - that's what we have one for...

  • Returning Visitors

    If you are a returning visitor who never received your confirmation email, then odds are your email provider is blockinig emails from our server. The only thing that can be done to get around this is you will have to try creating another forum account using an email address from another domain.

    If you are a returning visitor to the forum and can't log in using your old forum name and password but used to be able to then chances are your account is deleted. Purges of the databases are done regularly. You will have to create a new forum account and you should be all set.

32mm Drilled slides

  • Thread starter Thread starter kent
  • Start date Start date
K

kent

Guest
Does anyone have a BS32 slide hanging around you could measure the vacuum port on? The ones on my 650 have been drilled out to about .107 in. I know that Dyno Jet doesn't even have you drill them out that big.
 
You don't see much problem with that??? The dyno jet drill size for the stage 3 650 #39 that is .0995, where are you getting .1562, thats bigger than the dyno jet drill for my 1100. in any case .0995 to the factory size measured by Tom at .087 is a .0125 difference, why don't do drill your main jets out .0125 and tell me how that runs.
 
You must log in or register to reply here.
Back
Top