81GS650L Mystery Parts

[DaveP]

Reinstalled the air box and carburetors today after doing a full tear down, cleaning, and o-ring replacement for the carburetors. All of these parts and the head cover were removed by the PO when I purchased the bike, so I have not seen where some of the pieces go. I have two parts that were left in the parts box after today's work.

Can't figure out from the parts fiche or manual where these might go. Plastic cover probably not a big deal, but a bolt that size seems significant.

The bolt has a 14mm head.

Any ideas?

Thanks,
Dave P

 

[tkent02]

Tool tray. It's upside down.

The bolt could be anything.

 

[DaveP]

Tool tray. It's upside down.

The bolt could be anything.

Too bad they didn't include the tools...

Can't see where a bolt this size would be needed with the components that they had removed.

 

[Jcgonzal]

That bolt looks like it might be big enough for brake caliper mounting duty...

 

[GSX1000E]

Number 15 here would be about that size: http://www.partsoutlaw.com/oemparts/a/suz/50d3fdb2f8700230d8b4dad5/steering-stem-model-x
You might just want to make sure that they are both installed and tight.

 

[DaveP]

Number 15 here would be about that size: http://www.partsoutlaw.com/oemparts/a/suz/50d3fdb2f8700230d8b4dad5/steering-stem-model-x
You might just want to make sure that they are both installed and tight.

Not a stem bolt, but very close to the one you indicated. On the bike, those bolts are painted black and most other bolts on the bike are a plain head or a large number in the middle of the head.

This one is probably an aftermarket bolt. Approximately 10mm x 63mm. There are small markings on the head. Head markings: F S on the top and F593-C on the bottom which would be an ASTM SS bolt.

Could have just been mixed up in the PO's garage. I was short a couple of bolts that should have been provided too.