GS750 where do i put my tubes ?

[Anonymous]

Just got hold of a carb balancing kit but not sure where to fit the pipes ?

know the procedure for balancing them and have already checked all the float hights (26mm ?)etc, but cant see where the pipes fit on to the carb.

appreciate any help

thanks

Fred
1979 GS750 E (registered march 1980, is this one of the last ?)

 

[Anonymous]

Where do you put your tube? That sounds like a personal question! :wink:

But seriously, assuming your bike is like my 1979 GS750L, there should be ports on the intake manifolds just ahead of the rubber intake boots. The ports are at about the 7 or 8 o'clock position when viewed from the back of the bike. They are plugged with socked head (Allen) screws.

 

[Anonymous]

Thanks Brian, found them !,
to be honest i thought that this was where, but been told previously they were monted on the inlet rubbers.

the screws in mine look a bit rusty, are ther prone to be hard to get out , or shear ! ?

thanks regards

 

[Anonymous]

Mine are rusty too, and I was afraid of breaking them or stripping them. I soaked them with penetrating oil for a few minutes prior to removal, and they came right out without any trouble.