KZ1000 intake boots that work on the GS1000

[salty_monk]

http://www.z1enterprises.com/detail.aspx?ID=3245

Is this the set that a few have used? I know you need to turn the upside down & slot the bolt holes a little.....

I noticed the other day that mine are just starting to separate from the back plate a little so might be time for a set of these.

 

[sharpy]

You could try Sudco as the do lots of carb inlet manifolds............

http://www.sudco.com/CatalogJPG/134.jpg

or

http://www.sudco.com/CatalogJPG.html

 

[Big T]

http://www.z1enterprises.com/detail.aspx?ID=3245

Is this the set that a few have used? I know you need to turn the upside down & slot the bolt holes a little.....

I noticed the other day that mine are just starting to separate from the back plate a little so might be time for a set of these.

Those are the ones, especially for 29 mm Smoothbores

I think that Sudco chart is misprinted at 68 (rather than 58) mm for Suzukis

 

[salty_monk]

Thanks, the price has gone up a bit since I remember but I guess so has everything....

Do these have O rings & if so do they come with them (otherwise I'll get ordering a set of those too!)

 

[trippivot]

11060-1135 check it out. .

 

[Guest]

How come you use these instead of the ones for the 1000 specifically?

 

[salty_monk]

Price!