A
Anonymous
Guest
I have replaced the R/r with an Electrex. I discovered that the stator wires were all burnt and corroded where they connector under the tank. I cut off the connectors and rerouted the stator wires directly to the r/r. I ran a red wire directly to the Pos term on the batt, and a black wire directly to the Neg. It started right up and ran for about 5 minutes and then shut down. After a few seconds it could start again and then shut down in about a minute. After that it would only run for a second or two.
I'm thinking that it's a hot wire/connection some place, but I can't figure out where to look. Any ideas will really help.
I'm thinking that it's a hot wire/connection some place, but I can't figure out where to look. Any ideas will really help.